Simple silk bracelet tutorial

I am not a big jewellery wearer. I find I feel restricted and almost claustrophobic wearing jewellery of any kind. However, I have recently been making very simple silk bracelets that I love. They are made from my fine silk cords and really simple to make. Here's how.

What you will need:

Silk cord (Mine is 1mm thick)

Crimps (I used 2mm)

Jump rings (small)

Clasp (I used a lobster clasp)

Sewing thread

Scissors

Measuring tape or ruler

Crimper pliers

Two pairs ordinary pliers (for opening jump rings)

Method:

1. Measure your wrist to find out how long you want the bracelet to be. My wrist is 6.5 inches (16cm) around at the narrowest point but I want the bracelet to be a bit looser so I will make the bracelet roughly 7.5 inches (19cm) in length.

2. Take a length of sewing thread and fold it in half. Put the end of the silk cord in the loop of the thread pulling it through about half an inch (1cm). In a moment this will form the bracelet's first looped end.

3. Pull the two ends of the sewing thread through a crimp and pull the crimp down so that it goes over the silk cord to form a small loop (as in the photo above). Use your crimper piers to squeeze the crimp closed and catch both sides of the silk cord securely. Remove the sewing thread and trim the knot off of short end of the silk cord to neaten it.

4. Measure the silk cord from the end of the loop you just made to the measurement you decided on in step 1. In my case this was 7.5 inches. Using the length of thread, lay it under the silk cord at the 7.5 inch point and double it over, trapping the silk cord in the loop as in step 2.

5. Put a crimp over the two ends of thread (just like you did in step 3) and pull the crimp over the loop of silk cord. Check your measurement again - just to make sure your bracelet is the right length - then use your crimper pliers to squeeze the crimp closed, just like before.

6. Now you have a length of silk cord with two loops. Take a jump ring, open it and slip it onto one loop. Repeat with the other loop but add the clasp to the second jump ring too.

7. Fasten it on and wear a simple and original piece of jewellery that is ideal for the summer - or autumn, winter or spring. Make lots more and layer them up.

You can also add little charms to the jump rings, add a short length of chain to a shorter piece of silk cord or make an extra long one and wrap it your wrist around twice for variation.